Drawing ballooning

Drawing ballooning: a practical review checklist

Build a traceable inspection workflow with clear balloon numbers, drawing revision checks, and a review of extracted requirements.

By QuickFAI Team ·

Start with the drawing revision

Drawing ballooning assigns identifiers to requirements so an inspector can connect each requirement to a recorded result. Before numbering anything, confirm the part number, drawing revision, units, and the scope of the inspection with your team. A well-numbered drawing is only useful when it refers to the correct source.

Keep the source drawing with the inspection record. If the drawing changes, review the affected characteristics rather than assuming an older balloon map still applies.

Review more than the visible dimensions

Work through each sheet in a consistent order. Review detail views, section views, notes, and referenced requirements as well as the main view. Decide how your team will identify requirements that apply to several locations.

For each characteristic, check that the nominal value, tolerance, units, and relevant drawing context remain connected. A diameter symbol or a tolerance attached to the wrong value can change what the inspector measures.

  • Confirm every drawing sheet is included.
  • Check detail views and drawing notes.
  • Resolve duplicate or missing balloon numbers.
  • Match each balloon to the corresponding inspection row.

Treat OCR as a starting point for review

Automatic extraction can reduce repetitive entry, but the extracted data still needs a human review. Compare symbols, decimal separators, tolerance signs, and small text against the original drawing. If a requirement is ambiguous, resolve it before releasing the inspection plan.

QuickFAI brings drawing ballooning and measurement recording into the same browser workflow. Use the drawing as the source of truth while reviewing extracted characteristics.

Release a usable inspection plan

Before handing the plan to the shop floor, check that another inspector can locate each characteristic and understand what needs to be recorded. Include the intended measurement method where your process requires it.

This checklist is a practical workflow aid. Customer requirements and your approved quality procedures determine the contents and approval of the final inspection record.

Worked example · fictional part

From drawing callout to inspection characteristic

The same requirement appears on the drawing and in the table. Balloon 3 identifies the hole diameter: 8.50 mm with a ±0.10 mm tolerance. This illustration explains the workflow; it is not a customer drawing or a product screenshot.

120.00 ±0.0575.00 ±0.05Ø8.50 ±0.10ILLUSTRATIVE PART · UNITS: mm · NOT TO SCALE
Before: source requirements, without inspection identifiers.
120.00 ±0.0575.00 ±0.05Ø8.50 ±0.10ILLUSTRATIVE PART · UNITS: mm · NOT TO SCALE123
After: numbered requirements, ready for inspection planning.
Illustrative inspection rows · all dimensions in millimetres
BalloonCharacteristicRequirementMeasuredResult
1Overall length120.00 ±0.05120.02Pass
2Overall height75.00 ±0.0574.98Pass
3Hole diameter8.50 ±0.108.65Out of tolerance