Inspection preparation

How to prepare PDF drawings for inspection

A practical guide to readable PDF drawings, revision control, OCR review, and inspection handoff before measurements begin.

By QuickFAI Team ·

Use the clearest available source

Start with the original exported PDF when it is available. Before uploading a scanned drawing, zoom in on the smallest dimensions and tolerances. If you cannot distinguish a decimal point or a symbol, resolve the source quality before relying on extraction.

Check that the file contains all required sheets, that views are not clipped, and that the page orientation makes the drawing readable. Preserve the original file when preparing a working copy.

Make the inspection context explicit

Confirm the drawing revision and units before building the inspection plan. Record which part and manufacturing stage the plan covers. Where a referenced specification or customer instruction affects the inspection, make sure the inspector has access to the applicable information.

  • Verify part number and revision.
  • Check sheet count and readability.
  • Confirm units and general tolerances.
  • Identify notes that affect the inspection scope.

Check extraction against the PDF

Review nominal values, upper and lower limits, and symbols after extraction. Pay particular attention to crowded views and text near drawing lines. Do not infer a missing tolerance solely from what the software extracted; check the drawing context.

An image that looks acceptable at page level can still hide a small minus sign. Reviewing the requirement at a readable zoom level helps catch these issues before they reach measurement entry.

Try the handoff before inspecting the full part

Choose a few characteristics from different views and follow them from drawing to inspection row. Confirm that the inspector can locate the feature, enter a result, and find it again in the report.

QuickFAI connects PDF drawing ballooning with guided measurement entry. A short review of the prepared plan helps your team use that workflow consistently.

Worked example · fictional part

Follow a measurement into the inspection report

For balloon 3, the accepted interval is 8.40–8.60 mm. A measured value of 8.65 mm falls outside that interval and needs review before release. This illustration explains the workflow; it is not a customer drawing or a product screenshot.

120.00 ±0.0575.00 ±0.05Ø8.50 ±0.10ILLUSTRATIVE PART · UNITS: mm · NOT TO SCALE123
Ballooned drawing: the identifier stays connected to its requirement.
BALLOON 03 · HOLE DIAMETER

8.65 mm

Out of tolerance · upper limit 8.60 mm

Retain the original result, check the measurement, and follow the disposition process required by your quality procedure.

Illustrative inspection rows · all dimensions in millimetres
BalloonCharacteristicRequirementMeasuredResult
1Overall length120.00 ±0.05120.02Pass
2Overall height75.00 ±0.0574.98Pass
3Hole diameter8.50 ±0.108.65Out of tolerance